KME Hewlett JewelStik 1-2-3 Diamond Hone, Guide Rod – Coarse, Medium, Fine Grit

KNIFE SUPPLIES AUSTRALIA IS AN AUTHORISED AUSTRALIAN DISTRIBUTOR OF ‘KME SHARPENERS’ COMPANY PRODUCTS.

FOR YOUR PEACE OF MIND ALL ‘KME SHARPENERS’ COMPANY PRODUCTS PURCHASED FROM KNIFE SUPPLIES AUSTRALIA COME WITH A 100% AUSTRALIAN BACKED WARRANTY

For use with the KME Knife Sharpening System

Here’s an awesome accessory diamond hone for your Knives and broadheads.

This hone is particularly well suited for sharpening recurve blades, Karambits, Kukris, or any other knife or broadhead with a concave blade design.

This is an excellent solution for sharpening Simmons broadheads with the KME knife sharpening system.

Custom made in the USA for KME by Hewlett MFG, this hone has 3 oval shaped sharpening surfaces making it perfect for sharpening even the most extreme concave blade designs.

Includes a KME guide rod which attaches to the hone with a close tolerance friction fit. Just push the rod a few inches into the hone. The rod can be installed in either end of the hone so that the entire diamond surface can be utilized. (Does NOT include the knife sharpening system or the base shown in the picture.)

About using rounded hones:

When using rounded hone, care must be taken not to round over the tips of your knives.

This is because unlike a wide flat stone, a rounded rod has a very small area of blade contact. It is easy to go just a bit too far and slip passed the tip which will cause the point or tip to be deformed or rounded over slightly. You can be fairly aggressive throughout the length of the blade but be very careful when you sharpen the tip section.